screw anchors or wall plugs.
MOUNTING CLIPS
Ring-pull
Screen house
Installation hole 1
Installation hole 2
Lifting nut
There are three ways to install the screen. Use the following 3
diagrams to choose the appropriate installation method that suits your
environment.
1. On-wall installation method:
As shown in the picture above, measure and draw a reference line on the
wall to ensure the screen will be centered and mounted level. Use a stud finder to
locate the studs that are located to the outer most limits of your reference line.
Note: once the screen is place into the mounting clips, the screen can slide into a
centered position; hence mount placement does not have to be exact. Start with
The limit adjustment screws are found on the left side of the screen
housing, next to the power cord and control interface. The upper limit
adjustment screw is the white screw, while the lower limit adjustment
screw is the yellow screw. Adjustment of these screws is to be done
with standard slot screw driver.
To decrease how far down the screen deploys, you will need to adjust
the lower limit adjustment screw.
1) Fully deploy the screen by pressing the down button on the remote
(the screen will stop automatically.)
2) To raise the fully deployed position, turn the lower limit adjustment
screw counter clockwise. The screen will automatically raise
approximately 5/8" for each full rotation of the adjustment screw. This
will happen in real time. Continue this adjustment until the desired
position has been reached.
* To return this setting to the default position, repeat the above steps,
turning the lower limit adjustment screw clockwise. Please be aware
this will not adjust in real time. Screen must be retracted, and
re-deployed to reveal change. Be sure not to over adjust as this can
cause damage to the screen.
In the rare case the screen does not fully retract into its casing, you will
need to adjust the upper limit adjustment screw.
1) Fully retract the screen by pressing the up button on the remote (the
screen will stop automatically.)
2) To raise the fully retracted position turn the upper limit adjustment
screw clockwise. The screen will automatically raise approximately
5/8" for each full rotation of the adjustment screw. This will happen in
real time. Continue this adjustment until the desired position has been
reached.
Adjusting the black drop / Stop Position
