S
ECTION
4: N
ORMAL
P
ROCEDURES
C
IRRUS
D
ESIGN
N
ORMAL
P
ROCEDURES
SR20
4-14
P/N 11934-005
15.Alternator ...........................................................................................CHECK
a. Pitot Heat ............................................................................................. ON
b. Navigation Lights................................................................................ ON
c. Landing Light ...................................................................................... ON
16.Voltage ................................................................................................CHECK
17.Pitot Heat...............................................................................AS REQUIRED
• N
OTE
•
Pitot Heat should be turned ON for flight into IMC, flight into
visible moisture, or whenever ambient temperatures are 41 °F (5
°C) or less.
18.Navigation Lights .................................................................AS REQUIRED
19.Landing Light........................................................................AS REQUIRED
20.Magnetos ........................................................ CHECK LEFT AND RIGHT
a. Ignition Switch ..................................... R, NOTE RPM, THEN BOTH
b. Ignition Switch ......................................L, NOTE RPM, THEN BOTH
• N
OTE
•
RPM drop must not exceed 175 RPM for either magneto. RPM
differential must not exceed 50 RPM between magnetos. If there is
a doubt concerning operation of the ignition system, RPM checks
at higher engine speeds will usually confirm whether a deficiency
exists.
An absence of RPM drop may indicate faulty grounding of one
side of the ignition system or magneto timing set in advance of the
specified setting.
21.Engine Parameters ............................................................................CHECK
22.Power Lever............................................................................................. IDLE
• N
OTE
•
Verify smooth engine operation at idle speed of 700 to 750 RPM.
23.Fuel Pump .................................................................................................. ON
24.Flight Instruments, HSI, and Altimeter ...................... CHECK AND SET
25.Flight Controls........................................................ FREE AND CORRECT
26.Trim ....................................................................................... SET TAKEOFF
27.CAS Messages ....................................................................................CHECK
(Continued)
Reissue A
Содержание 2220
