CIRRUS DESIGN 2220, Руководство по эксплуатации для пилотов

Страница: 315 / 334

C
IRRUS
D
ESIGN
S
ECTION
8: H
ANDLING AND
S
ERVICING
SR20 C
LEANING
E
XTERIOR
S
URFACES
P/N 11934-005 8-25
Care of Graphics
Graphics require care similar to any fine paint finish. Use high quality
products designed specifically for use on automobile finishes. Use products
in accordance with the manufacturer’s instructions.
Graphics, like paint, are degraded by prolonged exposure to sun and atmo-
spheric pollutants. Store aircraft in a hangar, under a cloth cover, or shaded
area whenever possible. Protect aircraft from dew and rain which may
contain acidic pollutants (commonly found in large metropolitan areas).
• CAUTION •
If graphics start to discolor or turn brown as a result of exposure
to acidic pollution, immediately have a professional remove the
graphic from the aircraft to avoid staining the underlying paint.
To Wash and Clean Graphics
Wash graphics whenever the aircraft appears dirty. Contaminants allowed
to remain on the exterior may be more difficult to remove.
1.
Rinse off as much dirt and grit as possible with a spray of water.
2. Clean graphic with a wet, non-abrasive detergent such as 3M™ Car
Wash Soap 39000, Meguiar's NXT Generation® Car Wash, or Deep
Crystal® Car Wash, and a soft, clean cloth or sponge.
3. Rinse thoroughly with clean water.
4. To reduce water spotting, immediately use a silicone squeegee to
remove water.
5. Dry with a clean microfiber cloth.
To Pressure Wash Graphics
Although hand washing is preferred, pressure washing may be used when
necessary to remove dirt and contaminants. Pressure washing must be
performed in accordance with the following procedure:
1.
Ensure water pressure is less than 2000 psi (14 MPa).
2. Ensure water temperature is less than 180 °F (82 °C).
3. Use a spray nozzle with a 40° wide angle spray pattern.
• CAUTION •
Holding the nozzle of a pressure washer at an angle less than 90°
to the graphic may lift the edges of the graphic.
4. Keep the spray nozzle perpendicular to the graphic, and at a distance
of at least 1 foot (30 cm).
5. To reduce water spotting, immediately use a silicone squeegee to
remove water.
6. Dry with a clean microfiber cloth.
Reissue A