Circuit-test PSC-6916, Руководство по эксплуатации

Страница: 8 / 32

8
(8) Remote Sensing Terminal
(for model PSC-6916 only)
Warning • Do not short the remote sensing terminals
•
Connecting the remote sensing terminals in reverse
polarity will damage the power supply.
(9) Mode Selection Switch (Normal, Preset, Remote Control, Set Modes)
(10) Recall Selection Switch
(11) Analogue Remote Control Terminal
(12) Cooling Fan Air Intake Grill
(13) AC Input
(14) USB port (for access to computer to run cyclical operation with programmable
voltage, current, period time and cycle)
6. Control Mode Selection
There are 4 modes, Normal, Preset, Set and Remote Control mode for the power
supply.
Slide the Mode Selection Switch (9) to your desired Mode.
The power supply is factory preset to Normal Mode with maximum current level CC.
6.1 Normal Mode
6.2 Preset Mode
a. In this mode, the Rear Control Light is ON to indicate panel V & I controls
are de-activated.
b. There are 3 preset output P1/ P2/ P3 at the Recall Selection Switch (10)
c. The preset values are factory set as following table.
d. End user can set his own output rating, please refer to paragraph 6.3
This is the factory preset mode and the power supply output V, I are controlled
by the dual action tuning knobs. Push the knobs to toggle the coarse and
fine tuning, notice the subtle changes in brightness of related LED. Adjust
the knobs to your desired values by trying coarse and fine tuning. To check
the preset current level, just turn the Current Knob slowly in any direction.
The display will resume its normal brightness after few seconds to double
confirm your adjustment.