Circuit-test PSC-6916, Руководство по эксплуатации

Страница: 9 / 32

9
Recall No. Output Voltage Output Current
P1 5V Maximum
P2 13.8V Maximum
P3 PSC-6916: 15V
PSC-6932: 25V
PSC-6960: 55V Maximum
6.3 Set Mode - First enter into the Set Mode by pushing Switch (9)
to Set Mode slot.
The power supply is then ready to be preset.
a. Select the Recall Switch (10) to the position P1, P2 or P3 which you want
to set
b. Adjust the front panel voltage control knob to set your desired voltage value
c. Adjust the front panel current control knob to set your desired current
limit value
d. Repeat the procedure for remaining recalls P1, P2, P3 if desired.
e. Move Mode Switch (9) from Set to Preset position to confirm your settings.
NOTE:
All preset values will remain unchanged even after the power supply has been
turned off. Always check output voltage of Presets before connecting to Load.
To check the preset values, move Mode Switch (9) to preset position. Move
the Recall Switch (10) to P1, P2 or P3. The V and I settings of corresponding
RECALL P1, P2, P3 will be show on the panel meters.
6.3.1 To define the preset output P1/ P2/ P3.
a. Turn OFF the power supply
b. Push and hold both front panel voltage and current control knobs at the
same time
c. Turn ON the power supply again
d. Release front panel voltage and current control knobs
6.3.2 To reset the unit back to factory setting
6.4 Analogue Remote Control Mode
To control the output voltage and current by remote control connector (11)
Please refer to Section 9.