.
OG_STD-302S-429M_v11e
13
Circuit Design, Inc.
OPERATION GUIDE
Method of serial data input to the PLL
After the RF channel table plan is decided, the data needs to be allocated to the ROM table and read from there or
calculated with the software.
Together with this setting data, operation bits that decide operation of the PLL must be sent to the PLL.
The operation bits for setting the PLL are as follows. These values are placed at the head of the reference counter
value and are sent to the PLL.
1.
CS: Charge pump current select bit
CS = 0
+/-1.5 mA select
VCO is optimized to +/-1.5 mA
2.
LDS: LD/fout output setting bit
LDS = 0
LD select
Hardware is set to LD output
3.
FC: Phase control bit for the phase comparator
FC = 1
Hardware operates at this phase
The PLL IC, which operates as shown in the block diagram in the manual, shifts the data to the 19-bit shift register
and then transfers it to the respective latch (counter, register) by judging the CNT control bit value input at the end.
1. CLK [Clock]: Data is shifted into the shift register on the rising edge of this clock.
2. LE [Load Enable]: Data in the 19-bit shift register is transferred to respective latches on the rising edge of the
clock. The data is transferred to a latch according to the control bit CNT value.
3. Data [Serial Data]: You can perform either reference counter setup or programmable counter setup first.
CS
Inv alid Data
LDS
FC
SW
R14
R13
CNT=1
R1
1st data
2nd data
N11
N10
N9
N8
N7
N6
CNT=0
A1
1st Data
2nd Data
DATA
CLK
LE
MSB
LSB
t6
t5
t4
t3
t2
t1
t0
#: t0,t5 >= 100 ns
t1,t2,t6 >= 20 ns
t3,t4 >= 30 ns
#: Keep the LEterminal at a low level, w hen w rite the data to the shift resister.
STD-302
terminal name
Figure 2
