13
16. Install thrust plate assembly including thrust plate (21 or 51), washers (24 or 52), bolts (23
or 53) and spacers (22 or 51) on housing (2 or 24). Torque bolts (23 or 53) to value on
correct assembly drawing.
17. Install gasket (8 or 5) or O-ring (88) in groove in inlet head (26 or 2).
18. Install inlet head (26 or 2) using bolts (10 or 4) (and lockwashers (92 or 30) if present).
Torque bolts to value on correct assembly drawing.
NOTE:
Inlet head (26 or 2) can be rotated and repositioned in 90 degree increments to
suit suction piping. To change inlet position remove bolts (10 or 54) and rotate
inlet head to desired position. Install bolts (10 or 54) and torque to proper values
indicated on assembly drawing.
19. Install coupling hub key (16 or 31). Install and align pump and driver as specified in
General Instruction Manual, SRM00046.
FIGURE 3 – MECHANICAL SEAL DRAWING
