FuzzyScan
Pr
og
ram
mi
ng Man
ua
l
Configure Your FuzzyScan
54
PROGRAM
Operation Control
(F & L Series)
Operation Mode Setting
F_DEFAULT
Family Code Selection
P.C
Parameter Selection
Option Code
Operation Mode
SS
SS
SS
SS
SS
SS
SS
SS
SS
Low Power mode
Trigger mode
Presentation mode
Alternative mode
Flash mode
Force mode
Toggle mode
Diagnostic mode
Level mode
0
1
2
3
4
5
6
7
8
Low Power Mode (Low Power Triggering):
The scanner goes into idle state after scanning the bar code. You must press the trigger to wake up the scanner for operation.
It is very helpful for mobile data collection and application, which are concerned with power saving.
Trigger Mode (External Triggering):
The scanner goes into standby state after scanning the bar code. You must press the trigger to turn on the light source of the scanner
before scanning the bar code.
Presentation Mode (Auto Detection):
Presentation mode uses ambient light to detect the bar codes. The light source is off until the scanner detects an image which is
similar to a barcode. Then the light source turns on automatically to read the bar code. If the light level in the room is not high enough, Presentation Mode may not work
properly. You can choose different level of “Presentation Sensitivity” to meet your application (Please refer to the setting of “
Presentation Sensitivity
”).
Alternative Mode (Periodic Power Off)
:The scanner keeps the light source of the scanner turned on till the pre-defined light source on time is up. After the scanner turns
off the light source, you must press the trigger to turn on the light source again. After each good read, the timer counter of “Light Source on Time” is reset. For you do not
have to press the trigger frequently, it is very convenient for multiple scanning.
Flash Mode (Pulse Driven Reading):
The scanner flashes the light source of the scanner without using the trigger. If the scanner detects an image which is similar to a bar
code, the scanner forces on the light source automatically and scans the bar code. Flash Duty Cycle adjustment can change the frequency of the blinking.
Force Mode (Continued Power On):
The light source of the scanner is forced on for continued operation without pressing the trigger switch. This mode is convenient for
high speed bar code reading.
Toggle Mode (Repeat Reading):
The toggle mode is very similar to the Alternative Mode but without the pre-defined light source on time concern. You must press the
trigger to turn on the light source of the scanner to scan. The scanner keeps the light source turned on until you press the trigger again.
Diagnostic Mode (Test Reading):
This operation mode is specifically designed for diagnostic purposes. When this operation mode is selected, the light source of the
scanner is force on without regard for other programmable parameters, such as reread delay, redundancy, and so forth.
Level Mode (Auto Power Off):
When this operation mode is selected, the scanner continues to turn on the light source of the scanner before a good read or pre-defined
“Light Source on Time”. If the scanner decodes a bar code successfully, it turns off the light source immediately. After the scanner turns off the light source, you must press
the trigger to turn on the light source again. If there is no scanning operation performed during the pre-defined light source on time, the scanner enters the idle state after
the pre-defined light source on time is up.
FuzzyScan Laser model only have LED illumination (without laser aiming line) in
Flash/ Force/Toggle/ Diagnostics Modes
.
