5 - INSTALLATION AND INSTALLATION CONNECTIONS
The installation of the equipment must comply with the regulations and standards of the recipient country
The additional box must be positioned in the duct so that the temperature sensor is on the downstream side
(air supply)
Special recommendations:
• Connections must not place mechanical stresses on the unit.
• Keep all inspection doors closed while the unit is operating
•
If fitted outdoors (Classic PHE and Classic RHE/RHE-Z models only), the units must be installed so as to withstand the climatic
conditions in the installation location (risk of snow: height from ground/risk of wind: suitable mountings, swan-neck type
electrical connection to the unit etc.).
Flexible sleeve
Ensure all electrical components are earthed.
5.1 - OUTDOOR INSTALLATION ("Classic PHE" and "Classic RHE/RHE-Z" model only)
The installation of a "Floway" dual-flow unit outdoors requires a roof and a canopy to be fitted; these are usually supplied mounted*
and adapted to suit each configuration.
(* Supplied in kit form if delivery of the elements assembled is not possible)
Fitting the roofs:
The roofs for Floway units are designed to provide sufficient protection against adverse weather conditions, as they overlap the
edge of the unit by 80 mm.
Fitting procedure:
1 Fix the foam seal along the length of the unit. (50 x 20 foam seal).
2 Fix the roof panel(s) along the entire length of the unit.
50x20 foam gasket bonded for roof
curvature
3 Assemble the roof on the unit as per the following diagram
Ø 4.8 self-drilling screw
Roof
Side rail
Ø 22.2 blanking cover
Ø 4.8 sealed rivet or Ø 4.2 self-drilling
screw + sealed washer
EN-17 FLOWAY
