CIAS Elettronica S.r.l. CORAL-PLUS, Руководство по установке

Страница: 48 / 72


CIAS Elettronica S.r.l. Ed. 1.5
Installation Handbook page 47 of 66 CORAL-PLUS
TRANSMITTER TERMINAL BLOCK MS3
Term. Symbol Funzione
1 13,8V Supply Voltage for 485/232 converter (+13,8V )
2
GND Ground for RS 485/232 converter and data reference (0V )
3 LH High Data Line (+ RS 485)
4 LO Low Data Line (-RS 485)
TRANSMITTER CONNECTOR J2
Pin Symbol Function
1 GND Ground to MW oscillator
2
DRO Connection for MW oscillator
3 GND Ground to MW oscillator
TRANSMITTER CONNECTOR J3
Pin Symbol Function
1-2-3-5-8-9-10-11-14-15 N.C. Not connected
4
GND Ground
6
+13,8 V Supply Voltage (13,8 V )
7
GND Ground
12 +5 V Internal Supply Voltage (5 V )
13
OSC Measure for working Oscillator (+4V = OK, 0
or 8V = NOT OK)
16 +8 V Internal Supply Voltage (8 V )
TRANSMITTER CONNECTOR J4
Pin Symbol Function
1
GND Ground to Tamper Switch
2 ING Tamper Switch Input
3
GND Ground to Tamper Switch
TRANSMITTER SWITCHES SW3 SW2 SW1
Symbol Function
SW3 Hexadecimal switch for modulation channel selection
from 0 to F
SW2 Barrier Number selector (tens column)
SW1 Barrier Number selector (units column)
TRANSMITTER LEDS
Symbol Indication Default
D7 Fault
ON
D3 Tamper
ON
TRANSMITTER JUMPERS
Symbol Function Default
Jp1
OUT = Internal Modulation (Tx is “Master” Sync is outgoing)
IN = External Modulation (
Tx is “Slave” Sync is ingoing)
OUT
Jp2 Enable or disable the Fault and Tamper Leds
ON
Jp3 Modulation Selection type 50% - 10%
Don’t change
50%
Jp4 RS485 Line termination - Jp4 (left) line not terminated
OFF