TVDR4 – 9 – 16H
10
Factory Reset
Figure 15 — Factory reset switch.
The DVR has a
Factory Reset
switch to the right of the RS232 connector. This switch will only
be used on the rare occasions that you want to return all the settings to the original factory
settings.
CAUTION: When using the
Factory Reset
, you will lose any setting you have
made.
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, poke the straightened paperclip in the unlabeled hole to the
right of the RS232 connector.
4. Hold the switch until all the LEDs and all the segments on the Front Panel Display are lit.
NOTE: When the DVR successfully resets to factory defaults all the LEDs and the
segments on the Front Panel Display flash three times.
5. Release the reset switch. All of the DVR’s settings are now at the original settings it had
when it left the factory.
Connecting the Power Cord
Figure 16 — Power cord connector.
Connect the power cord to the DVR and then to the wall outlet.
