Chuphotic Venus Smart 1K, Руководство пользователя

Страница: 10 / 21

8
4. Operation (LCD model)
2) When the battery capacity decreases, the number of battery capacity indicators turned on will
decrease. If the battery voltage drops to the pre-alarm level, the alarm will beep every second to
remind the user of insufficient battery capacity.
3) The other four display pages are load percent page, actual load page, battery information page and
the maximum temperature page.
4.2.3 Bypass Mode
When operating in bypass mode set up through UPSilon software, the display on the front panel is shown
as the figure 5-4, the utility power indicator and the bypass indicator are turned on. Load information area
shows load value, and the battery level area indicates dynamically when the battery is not fully charged (the
battery level icons lit one after another circularly). When the battery is fully charged, all the level icons are
turned on.
1) When operating in bypass mode, the UPS
beeps every 2 minutes. If the “Function” key
is pressedfor more than 2 seconds, the
alarm will not beep (silence function). Press
the “Function” key more than 2 seconds
again to resume the alarm function.
2) If the utility power indicator blinks, it
shows thatthe voltage or frequency of the
utility power is out of the input range
of the UPS or there are problemswith
reversed polarity (L/N) of site wiring or
disconnect to the ground for protection.
3) The other four display pages are load percent
page, actual load page, input information
page and the maximum temperature page.
Notes: When operating in bypass mode, the backup
function of the UPS is not available and the power used
by the load is directly from the utility power via internal
EMI filter.
Figure 4-4 Bypass Mode
215 50.0
VAC Hz
OUTPUT
Figure 4-3 Battery Mode
220 50.0
VAC Hz
OUTPUT