Chroma 63800 Series, Инструкция по эксплуатации и программированию

Страница: 100 / 198

Programmable AC/DC Electronic Load 63800 Series Operation & Programming Manual
3-72
V s e t = 2 0 0 . 0 0 V I p ( m a x ) = 2 9 . 0 A
T I M E O U T = 0 0 : 0 0 : 0 0 C U T O F F V = 5 0 . 0 0 0
6. Press
5 then press ENTER to change the value to “00:00:05”.
V s e t = 2 0 0 . 0 0 V I p ( m a x ) = 2 9 . 0 A
T I M E O U T = 0 0 : 0 0 : 0 5 C U T O F F V = 5 0 . 0 0 0
7. Move the cursor by pressing (
◄
,
►
) to the command line of “CUTOFF V =”.
V s e t = 2 0 0 . 0 0 V I p ( m a x ) = 2 9 . 0 A
T I M E O U T = 0 0 : 0 0 : 0 5 C U T O F F V = 5 0 . 0 0 0
8. Press
8 , . , 5 then press ENTER to change the value to “8.500”.
V s e t = 2 0 0 . 0 0 V I p ( m a x ) = 2 9 . 0 A
T I M E O U T = 0 0 : 0 0 : 0 5 C U T O F F V = 8 . 5 0 0
9. After setting the parameter of the load, the
LOAD ON/OFF key should be pressed to turn
on the load, so that the load can sink the current. (The detailed information please refer
section 3.4.5 .)
If there is error during the procedures of inputting value, press CLEAR to
clear the value at any time and then input again.
3.17.5 Rectified Mode
Under timing mode to enter DC rectified timing mode press the RLC/DC RECT key.
In this mode the loading power I
set,
the value CF, LINE sync., frequency, maximum current
value I
p
(max) of the UUT. The loading timeout time and cutoff voltage can be set. If LINE sync.
selects YES, the frequency of loading current will load by frequency of the main voltage. On
the contrary, the loading current will load by users’ inputted frequency.
I s e t = 5 . 0 0 C F = 1 . 4 1 4 L I N E S Y N C = N O
F = 1 2 0 I p ( m a x ) = 5 0 . 0 T I M E O U T = 0 0 : 0 0 : 0 0
V = 0 . 0 0
C U T O F F V = 5 0 . 0 0 0
T = 0 0 : 0 0 : 0 0 : 0 0 0 m s
H O L D U P
D C