RPMSP Series Installation Guide
2
The projector is carefully packaged in a way as to protect it from any unnecessary
shipping damage.
When unpacking the projector:
•
Remove all packaging material from around the projector. Make sure
all vents are clear and no scrap pieces of material are lying in between
modules.
•
Check cable connections to ensure not became loose during shipment.
Refer to Table 1. for your specific projector model if cables need to be
reconnected.
Table 1. Cable Connections
'
D100U models
Electronics Module
Projection Head Module
Dual Lamp Module
J91
→
J90
J94
→
J89
P114
→
P115
'
500Xe models
Electronics Module
Projection Head Module
Ballast Module
J91
→
J90
J94
→
J89
J88
J102 to P103
The projector can be configured in two ways: with the lens at 0
°
(lens horizontal) or
90
°
(lens vertical). The latter is typically used in installations where a first surface
optical mirror is used. Refer to the instructions for your specific model to change the
configuration, if necessary.
WARNING
Projector must be powered down and unplugged
before performing any setup or service procedure.
NOTE: You will need the two brackets shipped with the projector, to change the
projector’s configuration from lens horizontal to lens vertical.
1. Disconnect cable connections made to the PHM.
2. Remove the lamp. See User’s Manual for instructions.
2. Unpacking
the
Projector
3. Projector
Configuration
For
RPMSP-500Xe
'
