-15-
Optional Color Wheel Installation
The projector comes with the high brightness color wheels in-
stalled. Additional rich color reproduction color wheels are sup-
plied. To replace the color wheels, refer to the following steps.
Note:
• Wait until the lamp house and the color wheel cool off.
• Make sure to install the same type of two color wheels at the same
time. When different types of color wheels are installed, ‘Non-
matching color wheels!‘ message appears on the screen.
Allow the projector to cool, for at least 45 minutes before you open
Lamp Cover. The inside of the projector can become very hot.
Loosen a screw on the Lamp Cover. Slide and open the
Lamp Cover until it makes a clicking sound. (See the right
figure.)
1
3
Loosen three screws and pull out the color wheel to be
replaced by grasping handle.
4
Turn off the projector, press the Main On/Off Switch to Off
and unplug the AC power cord from the AC outlet. Let the
projector cool for at least 45 minutes.
2
Replace the color wheel with a new one and tighten three
screws. Make sure the color wheels are set properly.
Put the Lamp Cover back and tighten a screw.
5
SCREW
LAMP
COVER
SCREWS
COLOR WHEELS
Maintenance
DS+750 Service Manual
020-000211-01 Rev. 1 (06-2009)
Содержание DS+750
