Christie CP2308, Руководство пользователя

Страница: 93 / 111

Inspecting the card cage filter
Check the condition of the card cage air filter monthly. Clean or replace the card cage air filter sooner
if you are operating the projector in a dusty or dirty environment.
The filter is located on the left side of the projector behind the air filter cover. Use only high efficiency
Christie approved filters.
Caution! If not avoided, the following could result in minor or moderate injury.
• Do not operate the product without the filter installed.
• Do not reuse an old air filter.
1. Loosen the two captive screws on the bottom of the filter cover.
2. Pull the cover out and down.
3. Slide the air filter out and inspect it.
If the filter appears dirty and you cannot see through it, replace it with a new paper filter, or
clean it (on page 95) if it is a washable filter.
If the filter appears clean, continue to step 4.
4. Replace the air filter with the airflow indicator facing toward the projector.
5. Install the air filter cover by inserting the two bottom tabs and then pushing the cover closed.
6. Tighten the two captive screws.
Inspecting the light engine compartment filter
The filter is located on the right side of the projector behind the service access panel.
1. Remove the top lid.
2. Reach into the projector and then loosen the first service panel screw.
Maintaining the projector
CP2308 User Guide 93
020-102535-03 Rev. 1 (08-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.