5 : M a i n t e n a n c e
CHRISTIE DIGITAL SYSTEMS
CineX35 Projector
5-7
May, 2004
5 . 4 . 8 . R
E M O V A L O F
S
H U T T E R
D
R I V E R
A
S S E M B L Y
Refer to item 7 in Figure 5-3: Inner Belt on page 5-4.
1. Relieve tension on outer belt (Section 5.4.2).
2. Relieve tension on
inner belt (Section 5.4.3).
3. Relieve tension on shutter timing belt (Section 5.4.4).
4. Remove four Allen head screws securing shutter driver assembly.
5. Remove shutter driver assembly.
5 . 4 . 9 . R
E M O V A L O F
M
O T O R
A
S S E M B L Y
Refer to item 12 in Figure 2-3 on page 2-3.
1. Disconnect motor's electrical leads at terminal block TB1-1 (item 19 Figure 2-3).
2. Relieve tension on outer timing belt (Section 5.4.2).
3. Remove cable ties holding motor cable in place by removing Allen head cap screws.
4. Remove four Allen head screws securing mounting plate with motor to motor bracket.
5. Remove motor assembly.
5 . 4 . 1 0 . R
E M O V A L O F
F
R A M I N G
L
A M P
1. Open framing lamp door, which is secured by two quarter-turn fasteners (item 1 in Figure
2-2 on page 2-2).
2. Remove lamp as with ordinary light bulb.
