5 : M a i n t e n a n c e
CHRISTIE DIGITAL SYSTEMS
CineX35 Projector
5-6
May, 2004
5 . 4 . 5 . U
L T R A M I T T E N T
A
S S E M B L Y
Disassembly of Ultramittent or attempted repair of components will
void warranty.
Refer to item 3 in Figure 2-2 on page 2-2.
1. Relieve tension on outer timing belt (see Section 5.4.2).
2. Remove two Allen head screws securing Ultramittent shoe.
3. Remove Ultramittent shoe closure assembly (item 4 in Figure 2-2 on page 2-2)
4. Remove four Allen head screws and washers securing Ultramittent assembly to
Ultramittent plate.
5.
Carefully
slide Ultramittent assembly out from non-operating side of projector.
5 . 4 . 6 . R
E M O V A L O F
S
O U N D
-
H E A D
A
S S E M B L Y
Refer to item 6 in Figure 2-2 and Figure 2-3.
1. Remove flywheel sound drum (item 17 in Figure 2-3).
2. Open door of sound readers, which is secured by two quarter-turn fasteners (item 5 in
Figure 2-2).
3. Disconnect LED leads at Dual LED Regulator.
4. Disconnect analog reader assembly connector.
5. Disconnect Video cable from digital reader assembly.
6. Remove four Allen screws in corners of base plate sound head.
7. Remove sound head assembly.
5 . 4 . 7 . R
E M O V A L O F
C
H A N G E O V E R
A
S S E M B L Y
Refer to item 22 in Figure 2-3 and Figure B-1.
1. Carefully pull four quick connect lugs from changeover solenoids (item 9 in Figure B-1).
2. Open framing lamp door (item 1 in Figure 2-1), which is secured by two quarter-turn
fasteners.
3. Unscrew knob changeover (douser).
4. Remove four Allen screws (item 14 in Figure B-1) (which holds changeover assembly)
through holes in light baffle assembly (item 1 in Figure B-1).
5. Remove changeover assembly out from non-operating side of the projector.
