Christie CC50-2301, Руководство по установке

Страница: 9 / 56

Section 1: Introduction
CC50-2301/CC67-3001/CC72-3301 Installation Manual 1-3
020-100248-03 Rev. 1
1.2.2 Using Christie PE50/PE67/PE72 Pedestals
It is strongly recommended that PE50-3602/PE67-3602/PE72-3601 pedestals be used with CC50/CC67/CC72
display cube enclosures. The installer must ensure that CC50/CC67/CC72 cube enclosures are mounted to or
within a secure structure that can adequately support the weight of the stacked display cubes. If a display wall
is built with any other platform, the installer must ensure that the platform is stable and can support the weight
of the display cubes (to their stacking limits), and that the platform provides enough mounting locations so that
each display cube is fastened to it using its four to six mounting points.
Ensure that pedestals are level before stacking display cubes. See also
External Support .
1.2.3 External Support
Stacked display cubes can tip over and cause injury or damage when not properly
secured. The display wall must be supported during and after installation to a structurally sound surface
such as a permanent wall or an installer-approved free-standing external support structure.
Display cubes must be stacked on a level surface. If display cubes are stacked on a non-level or inclined
surface, there is an increased risk that stacked cubes (even when mounted in secured or free-standing external
structures) could tip over and cause serious injury or damage. It is strongly recommended that PE50/PE67/
PE72 pedestals be used to create the platform for a CC50, CC67, or CC72 display wall.
1.2.4 Hardware
Hardware is provided for fastening one display cube to another display cube or to a pedestal. Unless otherwise
indicated, use all the hardware provided when fastening the various display cube products.
1.2.5 Lifting Display Cubes
Lift equipment MUST be used to lift display cubes into position on higher rows. A crew
of two or more can lift a display cube into position on the first row.
1.2.6 Airflow Considerations
It is important that the room temperature measured all around the display wall is
no greater than the operating
temperature stated in the product specifications.
It is up to the installer to determine, based on their
installation, how much open area is required around the display wall for adequate airflow.
1.3 Contact Information
For current contact information, refer to www.christiedigital.com/ .