Christie CC50-2301, Руководство по установке

Страница: 36 / 56

2-26 CC50-2301/CC67-3001/CC72-3301 Installation Manual
020-100248-03 Rev. 1
Section 2: Installation and Setup
2.2.12 Step 12 - Software Setup: Optimize Image Setup and Display
To optimize the projector settings to display the brightest and sharpest image possible, adjust each display
separately, then fine-tune the settings between all displays. See the projectors
User Manual for detailed
instructions on adjusting the various settings.
1. Display an external signal.
2. From the
Lamp menu, select a lamp operation mode: Lamp 1 or Lamp 2 . For the purpose of adjusting a
display wall, perform all software setups using this lamp mode.
NOTE:
For Entero projectors set the light mode.
3. Assign a unique identification number to each projector. This ID number enables communication to a
specific projector rather than broadcasting commands to all. For more information see the projector User
Manual .
4. Select the correct image orientation for the display by selecting Image Orientation from the Configura-
tion menu and select Inverted Front to display the image correctly on a rear screen display with mirrors.
5. Adjust the menu appearance on screen, by adjusting the options in Menu Preferences. found in the
Configuration menu.
6. From the Communications menu, enable the Broadcast key to relay commands from one projector to
others in the serial network.
7. Select Auto Setup , to allow the projector to optimize its settings for the current incoming signal.
8. From Size and Position , adjust Pixel Phase and Pixel Tracking to eliminate any noise from the displayed
image.
9. From Size and Position , adjust H-Position and V-Position to center the image on screen.
10. From Size and Position , adjust Size until the image is at the desired width and height. Adjust H-Position
and V-Position again to center the image after adjusting these settings. Continue this step until the image is
centered on the screen.