Chiron Technology IRIS 8 Series, Инструкция по установке и эксплуатации

Страница: 23 / 43

8 Advanced Installation - Data Calls
The Dialler supports data transmission either over ISDN (as a standard ISDN
Terminal Dialler) or over IP, for applications such as Video Surveillance. This
function is separate from the alarm-transmission and SMS features and can be
used simultaneously.
8.1 Installation
1. Ensure that the Dialler is connected to the communications network required,
either ISDN, Ethernet or GPRS, as described in the Installation section above.
2. Connect the terminal equipment (e.g. the Video Surveillance unit) to the
Dialler serial data port (labelled V24) using a standard modem cable. Note the
Dialler automatically detects whether the Local Configuration Software or
another device is connected to the serial port. If the serial port has been used
for configuration there are no changes that need to be made.
3. Configuration of the Dialler for data calls is via Hayes format commands. This
can normally be implemented from the attached. The Hayes commands
required for the different networks are shown in the section below.
4. Make a test call – the following activity on the LEDS should be seen:
•
TR is on (TR may go off temporarily when the call is cleared).
•
RD and SD flash to show the transfer of data.
Version 1.5 16/10/06 23