Chilli Penguin Chilli Billie, Инструкция по установке и эксплуатации

Страница: 19 / 46

• In some installations a heat shield may be advised but we recommend that heat
shielding cannot achieve more that a 50% reduction in distances to combustibles.
• A heat shield must include an air gap between the heat shield and the wall so the heat
is not transferred, see diagram below.
• The penguin enclosure is a form of heat shield.
3.m Heat Shielding
PENGUIN ENCLOSURE
Our penguin enclosure (round and square options) maintain the recommended distances
to combustibles below, to the rear and to the sides. They are made from a double skin
of steel with an air gap between the skins. The air gap is open top and bottom to allow
the free flow of air. It should be sited a minimum of 50mm from combustible walls. If you
are having a bespoke heat shield made, PLEASE take extreme caution, see the following
section.
HEAT SHIELDING - METAL/INSULATION BOARD
If you are not using a penguin enclosure and the structure of the building or surrounding
area is combustible, you can construct a wall mounted heat shield. We recommend that
this is double skinned, with the outer layer made of steel and the inner layer made of
either steel or cement board (A1 fire rated cement and glass reinforced insulation board),
illustrated below. A single skinned heat shield is not sufficient for a Chilli Billie. The
recommended air gap must be maintained, to allow cool air to circulate. The distances
should be maintained using metal fixings or brackets. Refer to the distances shown in our
insulation diagrams.
The following diagram illustrates the minimum requirements.
10mm Cement tile board
Combustible Wall or Surface
Steel heatshield
10mm Air gap
30mm Air gap
Page 17 of 43 www. chilli penguin.co.uk