CHIEF XFA1U, Руководство по установке

Страница: 6 / 16

XFA1U Installation Instructions
6
Assembly And Installation
The XFA1U is designed to be mounted to:
• a bare concrete wall with a minimum thickness of
8" (203mm):
• a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall; or
• wood studs spaced 16" on center with a
maximum drywall covering of 5/8”.
• a 2" x 4"-25ga minimum steel stud wall.
Attachment to Wall and Floor
IMPORTANT ! : The XFA1U does NOT need to be
attached to the floor as well as the wall, but it MUST be
attached to the wall. Do NOT only attach it to the floor
without also securing it to the wall!
Installing to Wood Stud Wall
1. Use a stud-finder to locate 16" studs.
2. Place column assembly against wall making sure to line up
attachment brackets with studs. (See Figure 1)
3. Mark hole locations at each mounting location. (See Figure
1)
4. Drill two 7/32” holes at marked hole locations. (See Figure
1)
5. If also attaching to floor, proceed ahead to “Attaching to
Floor” Section and attach to floor before securing to the
wall.
Figure 1
6. Install two 5/16 x 2 1/2” hex head cap screws (N1) through
holes on attachment brackets and into drilled holes on wall.
(See Figure 1)
Installing to a Concrete Wall
1. Place column assembly against wall at desired mounting
location. (See Figure 2)
2. Mark hole locations at each mounting location. (See Figure
2)
3. Drill two 3/8” holes at marked hole locations. (See Figure 2)
4. Install an anchor (N2) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall. (See
Figure 2)
5. If also attaching to floor, proceed ahead to "Attaching to
Floor" Section and attach to floor before securing to the
wall.
Figure 2
6. Install two 5/16 x 2 1/2” hex head cap screws (N1) through
holes on attachment brackets and into anchors (N2) on wall.
(See Figure 2)
Installing to Steel Studs
WARNING:
USING THIS PRODUCT INCORRECTLY
MAY RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Do NOT fasten the XFA1U into
only drywall!
3
4
(N1) x 2 6
7/32” (5.3mm)
2 3
(N1) x 2
6
(N2) x 2 4
3/8"