UNIVERSAL ENGINE SUPPORT
model no:
ES600
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
ensure that the engine support is in good working order. Take action for immediate repair or replacement of damaged parts. Use genuine
parts only. The use of unauthorised parts may be dangerous and will invalidate the warranty.
9
locate the vehicle in a suitable, well lit work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
ensure the vehicle handbrake is engaged and the engine/motor is switched off.
9
ensure all non-essential persons keep a safe distance whilst the engine support is in use.
9
When not in use, store engine support in a safe, dry, childproof area.
8
DO NOT
use the engine support if damaged.
8
DO NOT
allow untrained persons to operate the engine support.
8
DO NOT
exceed the rated capacity of the engine support.
8
DO NOT
use the engine support for purposes other than that for which it is designed.
2.
i
INTRODUcTION
The eS600 is suitable for heavy engines including 6-cylinder variants. Supports engine during maintenance operations including engine
mounting replacement. Beam is supported on 2 rubber covered feet with 3rd, height adjustable foot resting on the front of the vehicle.
Supplied with 2 short lifting chains
3.
i
SPEcIFIcATION
maximum Capacity ............................................................................ 600kg
length min/max ........................ 600/*875 (* allows 200 mm safety margin)
Width min/max ..................... 1010/*1210 (* allows 200 mm safety margin)
nett weight ...................................................................................... 16.84kg
Screw travel ....................................................................................... 65mm
4. ASSEMbLY
NOTE:
numbers in brackets refer to item numbers shown in the parts diagram
4.1.
Slide the moveable beam assembly (11) onto the beam (1).
4.2.
Slide the two moveable beams (7) into position as required.
NOTE:
The moveable beams (7) can be fitted either side of the
moveable beam assembly (11), as shown in fig.1. or one can be fitted to the moveable beam assembly (11).
4.3.
Adjust the position of the moveable beams (7) to provide the optimum weight distribution.
4.4.
Remove the bolts and washers (4 & 2) from the ends of the beam (1) and telescopic beam (16). Fit the standing platform assemblies
(3) and secure using the bolts and washers previously removed.
4.5.
Slide the telescopic beam (16) inside the beam (1).
4.6.
Remove the pin (13) from the support arm (15), slide the telescopic beam assembly (12) onto the support arm, adjust for the required
position and secure by fitting the pin through both items.
4.7.
Slide the telescopic beam assembly (12) into the moveable beam assembly (11).
4.8.
Remove the nut (5) and washer (6) from both “J” hooks (8), insert the “J” hooks through the locating tubes on the moveable beams
and refit the washers and nuts.
4.9.
The engine support is now ready for use.
eS600 Issue 2 22/10/18
Original Language Version
© Jack Sealey limited
Refer to
instruction
manual
fig.1
Wear protective
gloves
Wear protective
clothing
Wear protective
footwear
