CHIEF XFA1U, Руководство по установке

Страница: 12 / 16

XFA1U Installation Instructions
12
Cover Removal/Access/Re-install
NOTE:
The front cover comes with four button head cap
screws installed to provide additional security. But to
have quick access to the interior of the mount, these
screws do NOT need to be re-installed as the door can
be closed using the magnets inside the door.
1. Remove four button head cap screws holding front cover to
mount. (See Figure 16)
2. Pull front cover away from mount. (See Figure 16)
Figure 16
3. Install accessories and components as desired.
4. Install front cover back on mount using magnets. (See
Figure 17)
5. (Optional) Re-install four button head cap screws if
additional security is desired. (See Figure 17)
Figure 17
Cable Management
NOTE:
The following cable management options may vary
based on type of display being mounted and user
preference.
1. Place FCA clip (P) into groove on back of Fusion mount with
clip handle in a vertical position. (See Figure 18)
2. Rotate FCA clip (P) 90° in either direction until clip handle is
in a horizontal position. (See Figure 18)
3. Repeat Steps 1-2 for all clips to be installed.
Figure 18
4. Route cables along FCA clips (P) to be used for cable
management. (See Figure 19)
5. Use cable ties (Q) to secure cables to FCA clips. (See
Figure 19)
Figure 19
x 4
2
1
x 4
4
5
2
3
3
clip handle
(U)
4
5 (Q)