Installation Instructions
WM210-220-230-240S/SI
11
10. Place wall bracket over anchors and align mounting holes
in display mount with holes in anchors. (See Figure 12)
11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (N) through
1/4" washer (Q), corresponding mounting hole on wall
bracket and into anchor (P) and tighten until flush against
mount. DO NOT overtighten! (See Figure 12)
12. Repeat Step 11 for remaining 3 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 12
Installation to Wall Bracket
1.
Lift short throw projector arm (A) up to wall bracket (B) and
hook top plate onto cross bracket on wall bracket. (See
Figure 13)
Figure 13
2.
Slide lower plate onto cross bracket on mounting bracket.
(See Figure 14)
Figure 14
3.
Install two 1/4-20 x 5/8" hex head bolts (E) through holes on
short throw projector arm (A) and into sliding nuts on
mounting bracket (B). DO NOT TIGHTEN SCREWS AT
THIS POINT! (See Figure 15)
Figure 15
Drywall
Anchor metal channel
(B)
(N) x 4
11
Steel stud
(Q) x 4
(side view)
1
(A)
(B)
2
(A)
(B)
(A)
(B)
3
(E) x 2
