WM210-220-230-240S/SI
Installation Instructions
20
2.
Install two 1/4-20 x 1/2" button head security screws (T)
through holes in stop bracket and into holes in sliding nuts.
(See Figure 48)
Figure 48
Adapter Plate Bolts
1.
Remove projector from short throw projector mount
according to projector interface instructions.
NOTE:
For most projectors, it will be necessary to remove
projector prior to installing four security screws to
projector bracket. For ease of installation, it is
recommended to remove projector prior to performing
the following steps.
WARNING:
It is important to replace adapter plate bolts
ONE AT A TIME or adapter plate could fall from mount during
installation!
2.
Remove one of four bolts from adapter plate. (See Figure 49)
Figure 49
3.
Install one 1/4-20 x 3/4" button head security screw (U) into
hole (vacated by removed bolt in previous step) and into
plastic spacer. (See Figure 50)
4.
Repeat Steps 2-3 for remaining three bolts
one bolt at a
time
.
Figure 50
5.
Reinstall projector according to interface instructions.
2
(T) x 2
Stop
bracket
Sliding nuts
locations
Adapter plate
2
x 4
(one at a time)
Plastic spacer
Adapter plate
(U) x 4
(one at a time)
3
