CHIEF KITEC Series, Руководство по установке

Страница: 13 / 44

Installation Instructions KITEC/KITMC SERIES
13
Roll Adjustment
1. Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 25)
2. Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 25)
3. Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 25)
Figure 25
Height Adjustment
WARNING:
Failure to provide adequate support for this
mount during the height adjustment process can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the projector is
removed from the mount prior to adjustment and that the
weight of the mount is supported while the height is being
adjusted! Remove the projector from the mount prior to
height adjustment!
1. Remove projector from mount.
2. Loosen height adjustment screws. (See Figure 26)
3. While supporting the weight of the projector mount, adjust
height as desired. (See Figure 26)
4. Tighten height adjustment screws. (See Figure 26)
5. Reinstall projector to mount.
Figure 26
1
3
2
Example Only
(Interface bracket
varies dependent
on projector model)
(KITEC Series shown)
2 3 4
projector removed
height adjustment
screws
(KITEC Series shown)