CHIEF KITEC Series, Руководство по установке

Страница: 12 / 44

KITEC/KITMC SERIES Installation Instructions
12
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make
certain mounting slots in mount base slide under thumb
screws and that screws are seated in the back of slots.
4. Verify mounting screws are properly seated in mounting
slots in mount base.
5. Move locking lever to “Locked” position. (See Figure 21)
6. Insert key into lock and turn to secure projector to mount.
Figure 21
Installing Ceiling Plate Cover
1. Maneuver ceiling plate cover (A) so that it is able to wrap
around extension column. (See Figure 22)
2. Wrap ceiling plate cover (A) around extension column. (See
Figure 22)
3. Use two M6 x 6mm button head cap screws (D) to secure
ceiling plate cover (A) to CPA116 plate (A). (See Figure 22)
Figure 22
ADJUSTMENTS
YAW Adjustment
1. Loosen YAW adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 23)
2. Turn YAW micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 23)
3. Tighten YAW adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 23)
Figure 23
Pitch Adjustment
1. Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 24)
2. Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
(See Figure 24)
3. Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 24)
Figure 24
5
Example Only
(Interface bracket
varies dependent on
projector model)
(KITEC Series shown)
1
1
2
3 (D) x 2
(Rear view)
(A)
(KITEC Series shown)
1
3
2
Example Only
(Interface bracket
varies dependent
on projector model)
(KITEC Series shown)
1 3
2
(KITEC Series shown)