CHIEF KITEC Series, Руководство по установке

Страница: 11 / 44

Installation Instructions KITEC/KITMC SERIES
11
7. Maneuver legs so that sliding stud mount brackets and
screws are towards the middle of the projector. (See
Figure 18) and (See Figure 19)
8. Position sliding stud mount brackets and screws so that
SLMU main plate (J) can be evenly mounted to legs. (See
Figure 18) and (See Figure 19)
9. Use 1/4" hex key (V) to secure Allen nuts (U) to screws on
sliding stud mounts. (See Figure 18) and (See Figure 19)
NOTE:
The following examples are two of many possible
scenarios based on typical examples of mounting hole
patterns. Specific connection points will vary based on
the hole pattern. Multiple scenarios may be used for
each specific hole pattern as long as the weight of the
projector is centered and balanced after mounting.
Figure 18
Figure 19
Projector Installation
Install Projector With Interface Bracket
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO
NOT substitute hardware. Use only the hardware provided by
the manufacturer.
1. Orient projector with interface bracket. (See Figure 20)
2. Lift projector so that screws with thumb nuts are aligned
with mounting slots in mount base. (See Figure 20)
3. Slide projector with mounting bracket onto mounting slots in
mount base until screws are seated against the back of
mounting slots. (See Figure 20)
Figure 20
Three-hole scenario example
(U) x 3
9
(J)
sliding stud mount
brackets and
screws
Four-hole scenario example
(J)
(U) x 4
sliding stud mount
brackets and
screws
9
(E)
3
2
(KITEC Series shown)