SKU 91979
For technical questions, please call 1-800-444-3353.
Page
8
6.
Never attempt to move the oven while it is hot.
7.
Keep a fire extinguisher close at hand. Always keep a fully charged, commercial fire
extinguisher nearby the Oven in case of accidental fire.
8.
Never leave the Oven unattended once it is turned ON. Turn off the Oven, and wait
until it has completely cooled before leaving.
9.
Prior to turning ON the Oven, make sure to remove all tools and equipment from
inside the Oven.
10.
Do not clean the Oven with cleaners that are combustible or corrosive.
11.
Always unplug the Oven from its electrical supply source before performing any
inspection, maintenance, or cleaning procedures.
12.
Make sure to read and understand all instructions and safety precautions as outlined
in the powder coating manufacturer’s manual.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
WARNING:
People with pacemakers should consult their physician (s) before using this product.
Operation of electrical equipment in close proximity to a heart pacemaker could
cause interference or failure of the pacemaker.
WARNING:
This product contains or, when used, produces a chemical known to the State of
California to cause cancer and birth defects or other reproductive harm. (California
Health & Safety Code 25249.5, et seq.)
Assembly/ Operation
Your Compact Powder Coat Oven comes completely assembled. It is important that you read the
entire manual to become familiar with the product BEFORE you use the Oven. Before using the
Oven be sure that you have all parts described in the Parts List and Assembly Diagram located on
the last pages of this manual.
1.
Open the Oven Door and place the powder coated object on the floor of the Oven.
2.
Close the Oven Door (6). Close the Adjustable Vent (7) located on the side of the Oven by
sliding the Adjustable Vent cap over the hole-see Figure 1 on the next page. Make sure the
cap is snugly in place.
3.
Turn the Thermostat (1) to the desired temperature setting as recommended by the
manufacturer of the powder coating material-see Figure 2-next page. The temperature can
be set at a temperature between 0 and 480 degrees.
