SKU 91979
For technical questions, please call 1-800-444-3353.
Page
10
6.
Typically, the complete Oven cycle time for a powder coated object is obtained by adding the
“heating up” time, and the “dwell” time. The heating up time is the time it takes for the Power
coated object to reach the desired temperature. The dwell time is the time required for the
powder to cure properly. To obtain the complete Oven cycle time, consult the manufacturer’s
manual of the object being powder coated.
7.
Note the time until the Oven cycle time is completed. Once the cycle time is complete, turn
the Thermostat (1) to the OFF position. Open the Adjustable Vent (7) and allow the Oven to
cool.
8.
After allowing considerable time for the Oven and the powder coated object to cool, open the
Oven Door (6). Carefully remove the powder coated object from the oven, and unplug the
electrical plug.
Replacing the Heater Element
CAUTION:
Always disconnect the Oven from its electrical supply source and allow the Oven to
completely cool before performing any inspection, maintenance, or cleaning.
1.
The Heater Element (8) is easily replaceable but it will still need to be serviced by a qualified
technician. Only a qualified service technician should perform the following steps:
Make certain that the Oven is unplugged. Make certain that the Oven has not been used for
a considerable amount of time and that it is completely cool.
2.
Open the Front Door (6). Remove the perforated tray at the bottom of the Oven by
unscrewing the four screws. The Heater is located beneath the bottom tray.
3.
Unclamp the Heater. Turn the Oven upside down. Because of the weight of the Oven, it is
recommended that two people lift and turn the Oven upside down.
4,
Unscrew the Screws holding the bottom cover in place. Remove the connecting wires from
both ends of the Heater Element (8).
5.
Replace the existing Heater Element (8) with a new one.
6.
Replace the connecting wires at each end of the Heater Element (8). Replace the
bottom cover and thread the screws back into place. Clamp the Heater back into place. Turn
the Oven right side up. Replace the perforated tray at the bottom of the Oven and
thread in all four screws.
7.
To test the Oven, see the Inspection, Maintenance and Cleaning section of this
manual.
