SKU 66523
For technical questions, please call 1-800-444-3353.
Page 10
FIGuRE d
POWER
SWITCH
Grasp the Starter Handle and pull
4.
slowly until resistance is felt. While
holding the Handle, allow the Starter
Rope to rewind slowly. Then, pull the
Starter Handle with a rapid, full arm
stroke. Once again while holding
the Handle, allow the Rope to rewind
slowly. Repeat as necessary, until
the Engine starts.
(See Figure E.)
FIGuRE E
STARTER HANdLE
After the Engine starts and warms up,
5.
slowly move the Choke Lever to its
“RUN” position.
(See Figure C.)
IMPORTANT: Allow the Engine to
6.
run at no load until warm (approx. 3
minutes) after each start-up to allow
the Engine to stabilize.
Break-in Period:
Breaking-in the Engine will help to
1.
ensure proper equipment and Engine
operation, and will extend the En-
gine’s lifespan. The warranty is void
if the Engine is not broken in properly.
The first 25 hours of operation is the
break-in period.
During this time frame, DO NOT
•
exceed 75% of the Generator’s load
limit. In other words, the maximum
load during this break-in period
should be no more than 700 watts.
After the first 25 hours of use:
•
Change the engine oil.
•
Under normal operating conditions
subsequent maintenance follows the
schedule explained in the MAINTE-
NANCE AND SERVICING section.
Equipment Operation
Load And Circuit Breakers:
The total combined load through any
1.
combination of outlets on the Genera-
tor must not exceed the rated power
(1300 watts peak; or 1,000 watts
rated) of the unit.
Always reduce the load if the AC
2.
Circuit Breaker or DC Circuit Breaker
trips off. Once the load is reduced,
