CHESTER Craftsman, Инструкция по эксплуатации

Страница: 5 / 53

5. Maintain tools in top condition
Keep tools sharp and clean for the best and safest performance. Follow instructions for lubricating
and changing accessories.
6. Use recommended accessories
Consult Chester UK for recommended accessories. The use of improper accessories may cause
hazards.
7. Avoid accidental starting
Make sure the switch is in the ‘ OFF’ position before plugging in power cord.
8. Stop
The machine before putting material in the vice.
9. Always
Have stock firmly clamped in the vice before starting the cut.
10. Ground all tools
If the tool is equipped with a three­prong plug, it should be plugged into a three­hole electrical
receptacle. If an adapter is used to accommodate a two­prong receptacle, the adapter plug must
be attached to a known ground. Never remove the third prong.
Adjustment
Make all adjustments with the power off. When assembling follow the manuals instructions, this
will ensure correct instruction and a safe structure.
Working environment
1. Keep the work area clean
Cluttered areas and benches invite accidents.
2. Don’t use in a dangerous environment
Don’t use power tools in damp or wet locations, or expose to rain. Keep the work area well lit.
3. Keep children etc at a safe distance.
All children etc should be kept at a safe distance from the work area.
4. Don’t
Install & use this machine in an explosive dangerous environment.
Maintenance
1. Disconnect
Machine from the power source when making repairs.
2. Check damaged parts
Before further use of the tool, a guard or other part that is damaged should be carefully checked to
ensure that it would operate properly and perform its intended function check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged should be properly repaired or
replaced.
3. Disconnect tools
Before servicing and when changing accessories such as blades bits, cutters, etc.
4. To prevent
The corrosion of machined surfaces when a soluble is used as coolant, pay particular attention to
wiping dry the surfaces where fluid accumulates and does not evaporate quickly, such as between
the machine bed and vice.
Chester UK Craftsman Lathe
4