1224 East Warner Ave,
Santa Ana, Ca 92705
Tel: 1-714-545-5511
Fax: 1-714-850-6093
www.cherryaerospace.com
© 2007 Cherry Aerospace
Supplier’s Federal Identification Code: 11815
TM-G749A
Rev.: A
Date: 05/09/07
CR# 07-0097
LOCTITE
®
is a registered trademark of Henkel Corporation
DEXRON
®
is a registered trademark of GM corporation.
PARKER
®
is a trademark of Parker Hannifin Corporation
LUBRRIPLATE
®
is a trademark of Fiske Brothers Refining Co.
Seller warrants the goods conform to applicable specifications and drawings and will be manufactured and inspected according to generally accepted practices of
companies manufacturing industrial or aerospace fasteners. In the event of any breach of the foregoing warranty, Buyer’s sole remedy shall be to return defective
goods (after receiving authorization from Seller) for replacement or refund of the purchase price, at the Seller’s option. Seller agrees to any freight costs in
connection with the return of any defective goods, but any costs relating to removal of the defective or nonconforming goods or installation of replacement goods
shall be Buyer’s responsibility. SELLER’S WARRANTY DOES NOT APPLY WHEN ANY PHYSICAL OR CHEMICAL CHANGE IN THE FORM OF THE
PRODUCT IS MADE BY BUYER.
THE FOREGOING EXPRESS WARRANTY AND REMEDY ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES AND REMEDIES;
ANY IMPLIED WARRANTY AS TO QUALITY, FITNESS FOR PURPOSE, OR MERCHANTABILITY IS HEREBY SPECIFICALLY DISCLAIMED AND
EXCLUDED BY SELLER. THIS WARRANTY IS VOID IF SELLER IS NOT NOTIFIED IN WRITING OF ANY REJECTION OF THE GOODS WITHIN ONE
(1) YEAR AFTER INITIAL USE BY BUYER OF ANY POWER RIVETER OR NINETY (90) DAYS AFTER INITIAL USE OF ANY OTHER PRODUCT.
Seller shall not be liable under any circumstances for incidental, special or consequential damages arising in whole or in part from any breach by Seller, AND SUCH
INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES ARE HEREBY EXPRESSLY EXCLUDED.
INSTALLING PULLING HEADS
H749A-456 PULLING HEAD
1. Screw collet and collet bolt assembly onto end of
drawbolt piston. Tighten securely, using wrenches
on the flats provided.
2. Thread sleeve into end plug until it bottoms. Tighten
jam nut securely.
H753A-456 PULLING HEAD
1. Thread drawbolt onto end of drawbolt piston one
or two turns, then insert adapter fitting into end plug.
As the pulling head is threaded onto the riveter and
adapter fitting seats on piston, resistance to turning
will become greater. Continue turning until adapter
fitting seats in end plug. Rotate pulling head to posi-
tion it is to be used and tighten jam nut securely.
2. After attaching the H753A-456 to the riveter, adjust
sleeve by loosening jam nut. Insert largest diameter
CherryMAX to be installed into sleeve and rotate
sleeve until the jaws start to grab the rivet stem.
Tighten the jam nut securely. By this sleeve adjust-
ment, the stem can be made to release or to stay
in the head after installation.
H781-456 PULLING HEAD*
1. Thread drawbolt adapter clockwise onto end of
drawbolt piston one or two turns, then insert frame
adapter into end plug.
As the pulling head is threaded onto the riveter
and drawbolt adapter seats on piston, resistance
to turning will become greater.
2. Continue turning until frame adapter seats in end
plug. Rotate pulling head to position it is to be used
and tighten jam nut securely.
*H781-456 replaces H763-456
WARRANTY
