V1.1, June 08, 2021
Companion Plus User Manual
© Copyright 2021 Cheelcare
TM
. All rights reserved.
P a g e
|
9
Assembling the Docking Module for Rigid Manual Wheelchairs
1. Unscrew the bolt from the T-nut and position part #1 as shown on the picture. Slide the
T-nut under part #1 and screw that bolt into it. Leave it slightly loose as you will adjust its
position later.
2. Locate the box of clamps and select the pair that corresponds to the diameter of the
camber tube of your wheelchair. Insert the screws from the bottom of part #1 and secure
the base clamp halves to part #1 as shown on the picture above.
3. Disassemble part #2 from the Docking Module. Insert the screws from the bottom of part
#2 and secure the base clamp halves to part #2 as shown.
4. Measure the distance (
D
) from the front edge of the seat cushion to the crossbar.
Subtract 9m/3.5in from this distance. This will give you the proper length (
L
) at which to
position Part #2 in the next steps.
Part #2
Part #1
T-nut
Base clamp half
Distance between the crossbar
and the front edge of the cushion
D
L
