CHD 8-440, Руководство по установке

Страница: 13 / 16

VP330-KBD
Roland VP-330 MIDI Interface
Model 8-440 ver. 1.0
Copyright © 2015 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
13
Pic. 2.6.3 Pic. 2.6.4
c) Plug 50-pin connector of flat control signals cable to the interface board (KBD). The right
orientation of the connector is given by lock on the connector body (pic. 2.6.5).
d) Plug 3-pin connector of power supply bunched cables to the interface board (SUPP). The right
orientation of the connector is given by lock on the connector body (pic. 2.6.6).
Pic. 2.6.5 Pic. 2.6.6
e) Plug two 3-pin connectors of MIDI sockets to the interface board (M-IN, M-OUT). The right
orientation of the connectors is given by lock on the connector body (pic. 2.6.7). Be sure that MIDI
input and output sockets are not exchanged! If MIDI out socket had not been installed, see chapter 3.
f) Plug 4-pin connector of switch / LED bunched cables to the interface board (CTRL). The right
orientation of the connector is given by lock on the connector body (pic. 2.6.8). If control switch and
indication LED had not been installed, see chapter 3.
Pic. 2.6.7 Pic. 2.6.8
g) Plug 2-pin connector of shielded cable (originally leading to J16 on the main oscillator board
AGH19 / AGH17) to T-IN plug on the interface board (pic. 2.6.9).
h) Using shielded cable from the interface accessory, interconnect T-OUT plug on the interface
board with J16 plug on the main oscillator board (pic. 2.6.10).