DMX-355 User Manual
8
2005-12-15/10:45
Optional DMX
Controller
Daisy Chain Connection
Controller is not required for
Master/Slave operation
Optional CH-X
Controller
O
PERATING
I
NSTRUCTIONS
Operating Modes
The DMX-355 can be operated in three ways.
A stand-alone mode will listen to sound and run through its diverse range of built in programs. An
optional CH-X wired controller provides remote blackout control.
Master/Slave mode will allow the command of up to as many units you want in a synchronized light
show to the sound.
DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be controlled
individually using any universal DMX-512 controller.
Stand Alone
The Stand Alone mode is activated automatically when the fixture is absent of DMX signal or a
controller is not connected. The DMX-355 will run through its built in programs as it listens to the
sound. The optional CH-X wired controller also provides a blackout function.
Master/Slave
The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In
this mode, the first unit in the daisy chain will automatically command all other units following. The
programs are constructed based on the control of four units. An optional CH-X controller connected to
the first unit in the chain will allow a blackout function. Connecting the DMX-355 for (Master/Slave)
operation does not require any menu or setting selections. Simply connect each unit in a daisy like
fashion using qualified 3 pin DMX cables as described below.
M AST E R / S L AV E S ET T I N G S
1)
Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2)
Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on
as illustrated below in figure 5.
Note!
For additional information on linking fixtures read under section
“
DMX Primer
”
DMX Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to
customizing or creating a show. You can tailor your programming to suit a specific event. Whether it
is a wedding where a spot light may be required or a lead singer requiring a color solo, the
opportunities are end less. In this mode you will be able to control each individual trait of the fixture
independently.
