Operation
8
COLORado™ 6p Quick Start Guide Rev. 03
4. Operation
Control
Panel
Description
Button
Function
<SET>
Enables the currently displayed menu or sets the currently
selected value in to the selected function
<UP>
Navigates upwards through the menu list and increases
the numeric value when in a function
<DOWN>
Navigates downwards through the menu list and
decreases the numeric value when in a function
<EXIT>
Exits from the current menu or function
Powers the fixture On or Off (hold it for three seconds)
Control
Options
You can set the COLORado™ 6p start address in the 001~512 DMX range.
This allows for the control of up to 42 fixtures in the 12-channel STAGE 1
personality. In addition, the ID address system allows you to assign up to 66
fixtures within the same DMX address, thus multiplying the number of
fixtures you can control within a single universe. You can access the
fixture’s ID address system from channel 10 when in the STAGE 1 DMX
personality, and from channel 8 when in the STAGE 2 personality.
DMX Control
Without ID
Addressing
1) Go to
MENU
>
Run
Mode
and select
DMX
.
2) Go to
MENU
>
DMX512
and select a starting DMX address (
001~512
).
3) Go to
MENU
>
Settings
>
ID ON/OFF
and select
OFF
.
If ID Addressing is active in a fixture’s control panel, unintended
results may occur if DMX channel 11 values are higher than 0. Make
sure to disable ID addressing and to set DMX channel 11 to 0.
DMX Control
With ID
Addressing
1) Repeat steps
1
and
2
from
DMX Control Without ID Addressing
.
2) Go to
MENU
>
Settings
>
ID ON/OFF
and select
ON
.
3) Go to
MENU
>
ID
Address
and select an ID address (
1
~
66
)
4) When in STAGE 1, channel 10 controls ID addressing.
ADAS with ID
Addressing
1) Repeat steps
2
and
3
from
DMX Control With ID Addressing
.
2)
MENU
>
Settings
>
ADAS ON/OFF
>
ON
3)
MENU
>
Settings
>
ADAS fader no
>
12
4) To activate ADAS, set channels 8 and 10 to
255
.
5) To deactivate ADAS, set channels 8, 10 and 11 to
255
.
Personality
Setting
1) Go to
MENU
>
Personality
and select a personality.
2) Make sure that the starting addresses on the various fixtures do not
overlap due to the new personality setting. See the
DMX Values
section.
COLOR-CON
1) Go to
MENU
>
Run Mode
and select
CON
.
2) Connect and configure the COLOR-CON as per its user manual.
Power On/Off
Press
<EXIT>
for three seconds to power the fixture on or off.
Содержание COLORado 6p
Страница 1: ...Quick Start Guide ...
