Chattanooga Group ERGOSTYLE FX 5820, Руководство по обслуживанию

Страница: 20 / 31

18
Ergostyle ™ FX Tables
6 CALIBRATION
A. Specification
Inclinometer dependent
B. Equipment Required
Calibrated Digital Inclinometer with an
accuracy of ±0.50°.
C. Calibration Procedure
NOTE:
Two people are required to perform this procedure.
1. Make certain the FX Table Base Frame
is level.
2. Depress and hold the Up and Down Arrow
buttons while connecting AC power to the
table. See Figure 6.1.
3. Release Up and Down Arrow buttons. Unit
will start in Calibration Mode. Display will
read; "Move table to -13 degrees then
press start".
4. Zero the Digital Inclinometer on the lower
frame of the table.
5. Raise the hinged Pelvic Cushion and place
the Digital Inclinometer on the Pelvic
Section Frame.
6. Release the Flexion Lock and manually
adjust the Flexion Angle up until the Digital
Inclinometer reads 13 degrees. If 13 degrees
cannot be obtained, raise the Pelvic Section
to the mechanical limit. Manually hold the
Pelvic Section in position.
7. Press the START/STOP button.
8. When the display reads "Move Table to +16
then press start", manually adjust the Flexion
Angle down until the Digital Inclinometer
reads -16.0 degrees. If -16 degrees cannot
be obtianed, lower the Pelvic Section to the
mechanical limit. Manually hold the Pelvic
Section in position.
9. Press the START/STOP button. The table is
now calibrated and the display will change
to the normal operation mode.
10. Disconnect unit from AC power source.
11. Reconnect unit to AC power source and
visually verify the the Control Panel is
displaying the normal operating
mode menu.
12. Press the START/STOP button to begin a
treatment. Compare the angle readings
from the display with the Digital
Inclinometer. The readings on the Digital
Inclinometer should be the same as the
display ±2°.
6.1 FLEXION CALIBRATION AUTO FLEXION TABLES ONLY
FIGURE 6.1