Charnwood W618, Руководство по эксплуатации

Страница: 7 / 20

- Attatch the two sliding carriage support arms to the
underside of the cast iron saw table using 4 off M6 x
50mm countersunk bolts and 4 off M6 nut and washer
(Fig.6)
- Place an M6 x 16mm hexagen head bolt in each of
the 4 clearance holes on the two support arms and
loosely put an M6 nut and washer on the bottom of
each (Fig.7)
- Slide the extruded carriage arm onto the
four M6 x 16mm bolts (Fig.8)
- Slide the sliding carriage table onto the extruded arm and then using a straight edge
across the sliding table and the saw table fit and adjust the four M6 x 30mm hexagen
head bolts until the sliding table is approximately 0.5mm above the saw table
(Fig.9,10,11).
- When the level is set correctly tighten the
four M6 nuts on the M6 x 16mm hexagen
head bolts underneath the extruded arm on
the suport arms (Fig.12)
Fig.6
Fig.7
Fig.8
Fig.9
Fig.10
Fig.11
Fig.12