Charnwood W618, Руководство по эксплуатации

Страница: 4 / 20

Large stock . Do not attempt to saw long or wide boards unsupported where spring or weight could
cause the board to shift position.
Job completion . If the operator leaves the machine area for any reason, he should turn “off” the power
to the table saw motor and wait until the saw blade comes to a complete stop before his departure. In
addition, if the operation is complete, he should clean the table saw and the work area. NEVER clean off
the table saw with power “on” and NEVER use the hands to clear sawdust and debris; use a brush.
If you are not thoroughly familiar with the operation of this circular sawbench, obtain advice from your
supervisor, instructor or other qualified person.
Drugs, alcohol, medication . Do not operate this machine while under the influence of drugs, alcohol,
or any medication.
Health hazards. Some dust created by power sanding, sawing, grinding, drilling and other construction
activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
* Lead from lead-based paint.
* Crystalline silica from bricks and cement and other masonry products.
* Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area, and work with approved safety equipment,
such as those dust masks that are specifically designed to filter out microscopic particles.
Use proper extension cord : Make sure your extension cord is in good condition. When using an exten-
sion cord, be sure to use one heavy enough to carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of power and overheating. If in doubt, use the next
heavier gauge the smaller the gauge number, the heavier the cord.
General Safety Procedures for Table Saw
This machine has been built exclusively for woodworking. Do not alter the design of the machine or use
it for purposes not intended by the manufacturer. The manufacturer is not liable for damage or injury,
which results from incorrect assembly, operation or electrical connections. This machine must be operat-
ed under strict safety regulations. This is the only way to reduce the risk of accidents.
Location
Certain types of woods. press boards, etc. produce hazardous dust emissions when being processed.
For this reason, processing procedures must be performed with an exhaust unit (air speed at the con-
nection points: 20m/s) Be sure to switch on the machine and the exhaust unit simultaneously. The main
cable plug must be connected as appropriate for the electrical installation and must have an earth lead
(or a directly earth conductor for 380 V). It is advisable to have a qualified electrical connection.
Appropriate lighting must be provided in the work area.
The Operator
Read the operating manual carefully to prevent machine accidents. Never work while under the influ-
ence of drugs, alcohol or medications. Wear tight-fitting work clothes, safety goggles and safety shoes
and tie back long hair. Remove rings, wrist watches and bracelets before working.
Ear protection is recommended. Never climb onto the machine table: the machine may fall and cause
injuries.
Keep children and visitors out of the work area.
Before working
Check that the sawing tool type is suited for the intended work. Immediately replace damaged or dull
sawing tools. Only work with the appropriate standard accessories. Always work with well-sharpened
sawing tools increase the risk of wood kick back. Note the correct rotational direction. As a general rule,
check that sawing tool wrenches and other items have been removed. Check that the sawing tool can
rotate freely and does not contact the limit stop, the safety equipment, the work piece or other objects.
Keep out of the kick-back zone.