Charnwood W618, Руководство по эксплуатации

Страница: 12 / 20

Adjusting the cutting height
Adjust the height with the hand wheel (Fig. 41)
Select a cutting height such that the saw blade teeth still protrude from the work piece to be cut.
(Fig.42)
Adjusting the Blade Angle
Release the lock knob A (Fig.43). The saw blade can be tilted by up to 45º by rotating hand wheel B
(Fig.43). Once the desired angle is achieved lock the angle using lock knob A.
Note: The maximum depth of cut is reduced by 10 mm at angles of 30º or more.
Working with the circular table saw
Only use sharp, undamaged circular saw blades. Adjust the angle of the blade. Adjust the height of the
blade. Adopt a working stance as indicated in the figure. Keep out of the danger zone. (Fig 44)
Feed the work piece with both hands (be sure to use a push stick near the saw blade) until it is behind
the riving knife. Secure longer work pieces so that they do not flip after the cutting procedure (i.e. with a
table extension or roller stand). (Fig.45)
Cutting narrower work pieces, edges and strips
Use the flat edge of the rip fence for work pieces narrower than 120 mm. Use a parallel
intermediate piece if necessary. Secure longer work piece so that they do not flip after the cutting proce-
dure
(i.e. with a table extension or roller stand). (Fig 46)
Fig.41
Fig.42
Fig.43
Fig.44