Charnwood W618, Руководство по эксплуатации

Страница: 11 / 20

OPERATING INSTRUCTIONS
Mounting and adjusting the Riving Knife
Loosen the flange base with a 13 mm wrench and insert the riving knife. Adjust the riving knife and be
sure to maintain a distance of approx. 3mm to the saw blade (Fig. 34). Securely fasten the riving knife
with screw. Check that the riving knife is parallel to the saw blade by means of the table insert (Fig. 35).
Adjusting the Rip Fence
The scale must be adjusted so that it reads the correct value. Set the fence to zero and lock it in place.
undo the six pozi srews slightly allowing the scale to be adjusted left or right as required. You may need
to readjust this when changing to a blade of different width.
Next check the fence is parallel to the sawblade. Use the slots for the mitre fence as an optical guide. It
can be adjusted using the same six pozi screws.
(Fig. 36) & (Fig. 37).
The fence itself can be fitted in two different ways depending on the type of work to be cut. To change
the fence undo the hex head bolt underneath the fence (Fig. 38)
(Fig. 39) & (Fig. 40) show the two fence positions. Set up the fence as shown in Fig. 39 to make small
or thin cuts.
The rip fence can be used on the left or the right side of the saw blade.
NOTE: Regularly check that the fence is parallel to ensure perfect cutting.
Fig.35
Fig.34
Fig.36
Fig.37
Fig.38
Fig.39
Fig.40