Place the crosscut fence with the
open side face down and the
plastic tip to the right.
Slide the pivot block and the
locking block onto the back side
of the fence with the head of the
bolt in the T-slot.
The Locking block has a T-
shaped foot plate, slide it into the
slot in the table.
The Work clamp passes through
the pivot block and locates in the
large hole at the front of the
carriage.
The work clamp should be
locked in place using the small
grub screw in the front edge of
the carriage.
Fit the flip-over length stop by
feeding the head of the bolt into
the T-shaped slot on the top side
of the fence.
The ratchet handle locks the
stop in place.
The stop plate can be flipped
over to engage or disengage it.
From underneath the carriage,
push up the locating stop pin.
Use a square to check the
crosscut fence is set at 90
degrees to the blade when it is
pressed against the stop pin.
If necessary, adjust the stop by
loosening the locking ring and
grub screw. Put a screwdriver
into the slot to rotate the stop to
set the angle.