Charlton & Jenrick Valor LEX2, Инструкция по эксплуатации

Страница: 22 / 28

19
6b.42 Different types of batteries or new and used batteries
are not to be mixed.
6b.43 Batteries are to be inserted with the correct polarity.
6b.44
If the appliance is to be stored unused for a long period, the batteries
should be removed.
6b.45 The supply terminals are not to be short-circuited.
Resetting the Thermal Cut Out
6b.46 The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance
overheats, e.g. when covered. If the heater stops operating while the
flame effect continues working normally, this indicates that the E.S.
Control is in operation. The E.S. Control can only be re-set after the
appliance has cooled down, and the appliance has been reset. Re-setting
of the E.S. Control proceeds is as follows:
6b.47 Switch off the appliance (Manual On/Off switch) and leave it of for
approximately 10-15 minutes.
6b.48
Remove any obstruction to the fan heater outlet or fan blades etc. Make
sure that the power supply is disconnected with the plug socket outlet while
doing this.
6b.49 Switch on the appliance and the E.S. Control will be re-set.
6b.50 Ensure that the appliance is functioning correctly. If the E.S. Control operates
again, the appliance should be checked by a competent electrician.
WARNING:
Before any maintenance or cleaning of the exterior of the fireplace, the unit
should be disconnected from the power supply until it is cool off.
ALWAYS turn the heater OFF and unplug the power cord from the outlet
before cleaning, performing maintenance, or moving this fireplace. Failure
to do so could result in electric shock, fire, or personal injury.
Remote Controls Battery Replacement
7.1 When the batteries are at full power, the battery symbol will show
7.2 When the batteries are half full, the battery symbol will show
7.3 When the batteries are out of power and need replacing immediately, the
battery symbol will show