Charlton & Jenrick INFINITY 480 BF, Руководство пользователя

Страница: 30 / 41

30 LT 6935 (ISS 4)
damage the gasket, and ensure an adequate seal is made.
SECTION TWELVE: Assemble the appliance (Installation Instructions)

Taking special care remove the ceramic liner set from
within the packaging. The rear liner is in two pieces. Place
the bottom rear liner upon the top edge to the air tray.
Angle the upper rear line into the fire box assembly and
place on top of the rear bottom line.

With the two rear liner in position. Offer the LH
and RH side liner into the bottom brackets within
the burner Shelf assembly. (Please note the
patterned edge must be positioned along the
front). Push the top of the liner back into the
chamber sides and secure using the fixing screws
and fixing brackets provided.

Fit the burner cover within the base of the burner tray.

Position the shapes components as described in section
four of this manual; it is important that the shapes are positioned exactly as
described to ensure the correct operation of the appliance. Badly positioned
shapes may result in the gas flame being driven forward onto the glass and
permanently marking it.
The fireplace frame can now be fitted by sliding the assembly over the 4mm location studs
positioned on the LH and RH flange of the fire box. When positioned tighten all six off fixings.

Taking great care, locate the glass panel within the gap between
bottom retaining bracket and glass seal.

When located push back against the seal and locate and tighten
the three fixing brackets. (Please note over tightening the fixing
nuts can result in damage to the glass panel).
Burner cover assembly