Chaparral 2012 Signature, Руководство владельца/оператора

Страница: 38 / 151

Figure 3.1 370,350,290 Battery Panel
3-3
Recommended settings are as follows:
1. All Switches Off
When boat is not in use or power is not required, turn all
switches to OFF. The only power supplied at this setting is
the automatic bilge pumps, carbon monoxide detector (if
equipped), stereo memory and high water alarm.
2. #1 Battery Switch ON
To start the engine, place switch in ON position. With this
setting, power will now be supplied to your engine.
3. #2 Battery Switch ON
For cabin or accessory power, place the switch in the ON
position. Power will now be supplied to your boat from the
House battery.
Note: Chaparral does not recommend leaving all three
switches on when the engine is off. This will drain both batter-
ies and you will not have a starting battery.
4. #1 Battery, #2 Battery and Parallel Switches ON
If both batteries are low, you still have the option of starting
the engine by combining the output from both batteries.
Note: When recharging a low battery, be sure to run the engine
for a sufficient amount of time to fully recharge the battery.
330, 310 Battery Panel
NOTE: Emergency parallel switch is located at the helm. Use
only to connect the port and starboard engine battery. For
starting only.
270 Standard Seating Battery Panel
NOTE: Parallel switch is for emergency start only. Do not
leave in the on position while underway.
Each of the three battery switches have two positions.
Constant power source is the house battery.