DVR USER MANUAL - Issue 3 - 12/2013
| 14
CHANNEL SAFETY SYSTEMS
t: 0845 884 7000 | w: www.channelsafety.co.uk
CHAPTER 3: DVR INSTALLATION
3.1 HDD Installation (Applicable to the model with HDD drawer)
Caution: Please do not install or take out hard drive when CVR is running!
(1) The model has a HDD drawer. Please use provide key to take out the HDD drawer and put HDD into the drawer correctly.
(2) Cut power first, and then remove screws and open DVR upper cover carefully;
(3) Insert Power Cord and data cable into Pin of hard drive securely;
(4) Remove the screws on the HDD bracket; fix the HDD to the bracket and then fix the bracket with HDD to DVR body
(5) Put the upper cover back carefully, re-attach screws.
Note: If user requires higher performance HDD, We strongly recommend you use a special hard drive for security and protection
3.2 Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC connector (Refer to section 3.2
- Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of DVR respectively (refer to system
figuration on Chapter 8).
3.3 Power Supply Connection
Please only use the power adapter supplied with the DVR.
After the power is on please make sure the video I/O is connected well to the audio device with BNC cable.
