Chandler Engineering Ametek Quizix 5000 Series, Руководство пользователя

Страница: 141 / 155

GLOSSARY
[139]
motor cable
This cable is permanently attached to the motor and connects
the motor to the motor driver.
motor driver
This provides power for the pump cylinder and relays status
information to the pump controllers.
motor extension
A mechanical assembly which lengthens the distance between
the motor and the pump housing in high temperature pump
systems. This allows the Pump Housing to be heated inside
of an oven while keeping the motor and harmonic gearing
unheated outside of the oven.
motor extension cable
This cable, with a 9 pin DB type connector at each end, connects
the dual motor driver to the motor. It is used when the driver
needs to be at a greater distance from the pump cylinders.
motor resolution (in steps)
This is the number of steps the motor takes to complete one
complete turn, or one revolution.
motor shaft The portion of the motor that rotates.
motor shaft key
This part keeps the Harmonic Drive from turning when the
motor shaft rotates.
not inst (not installed)
This message will appear in the motion status field when the
controller cannot detect the presence of a pressure transducer,
motor driver or pump cylinder. No pump cylinder actions can
be taken through the PumpWorks software when a pump
cylinder is detected as not installed.
num lock
A key on the computer keyboard which, when pressed, will
allow you to use the numbers on your numeric keypad.
numeric keypad
This is located on the right hand side of your computer
keyboard. It has numbers, arrows and cursor movement
options.
offset The electrical shift of a signal around the zero reading.
open-end wrench
This is a wrench with a “U” shaped, or open, end that is used
to loosen or tighten bolts.
operating mode This term refers to the way the pumps are operated. An
operating mode is a particular configuration, or set-up, that
allows the pump system to be operated in a specific pre-
determined manner.